Camera Radio Mic Holders

RMH-1S

"Audio 2020" Single Radio Mic Holder

Single radio mic holder designed holder an Audio RMS 2020 radio mic. Using one of the many quick release brackets available the RMH-1S can be fitted to most broadcast cameras. The RMH-1S can also be fitted directly to the Canon XL-1 camera shoulder bracket accessory.

RMH-1

"Audio 2020" Dual Radio Mic Holder

The Hawk-Woods dual radio mic holder will accept two receivers dx2000/2020. Power is normally supplied using a DC cable from the camera to the holders 4 pin chassis mount DC input. The output voltage supplied via a further two Hirose connectors are regulated at 12volts. This allows the RMH-1 to be used with any battery system without causing potential damage to the radio mics due to over voltage. There IS a full range of quick release camera brackets available, to fit most cameras. Both powering and audio cables can be supplied to suit all situations.

Radio Mic Holder Powering Cables

(Note: Both 12 & 18 inch powering cables available).

Hirose on camera

Hirose 4p - Hirose 4p powering cable.

Paglok fitting

BP90 (2.1mm Plug) - Hirose 4p powering cable.

Power Tap

Power Tap - Hirose 4p powering cable.

Radio Mic Audio/Power Cables

Suit rear mounted bracket

RMC-1

Single 2000/2020 Audio/Power cable 32cm

RMC-1S

Pair 2000/2020 Audio/Power cables 32cm

Suit forward mounted bracket

RMC-17

Single 2000/2020 Audio/Power cable 45cm

RMC-17S

Pair 2000/2020 Audio/Power cables 45cm

Radio Mic Holder Bracket Options.

Forward camera mounted bracket

RMB-4

Sony DVW 700, DVW-790 and most other Sony Betacam's

RMB-5

Sony SX Camera's

RMB-6

Sony DSR-300,DSR-500 Camera's

Rear mounted bracket

RMB-2

Sony or Other "radio mic compatible fitting" NP1 battery box

RMB-3S

Various cameras fitted with Paglok/Anton Bauer battery system